Drivers seat not working

shmelvin

New Member
Messages
5
Likes
1
City
Gillette
State
WY
Country
United States
What I Drive
2015 ford fusion
#1
My driver's seat isn't working, the fuse is blown. I replaced it and after a short time it blew again. It was working fine until (and I could be completely wrong on this) I adjusted the lumbar support. Also, the passenger seat works fine except for the lumbar. This car is new to me, is this common and if so, does anyone know the fix?
 
OP
S

shmelvin

New Member
Messages
5
Likes
1
City
Gillette
State
WY
Country
United States
What I Drive
2015 ford fusion
Thread Starter #2
After reading other posts I found that both lumbar motors had the wires pulled out. What a joke, they were too short and not even crimped in the plug. Once I lengthened the wires and crimped the connections all is good. Though! after two hours of trying to get the zippers to move more than an inch I just cut the bottom and took the puller of and ordered two "Fixnzips" from Amazon.
 


Top