Replaced low pressure fuel sensor for stalling, now code p2196 a day later

H

harryman

New Member
#1
Messages
1
Likes
0
City
Pflugerville
State
TX
Country
United States
What I Drive
2016 Ford Fusion 1.5L Ecoboost
#1
Hi,

Car was stalling when stationary. Didn't check codes at this point, seemed pretty obvious based on research. Replaced low pressure fuel sensor (Dorman brand). Check engine light went off for drive or two. Now the light is back on with code p2196, O2 sensor. Thoughts? Replaced spark plugs a couple months ago.

2016 1.5L Ecoboost, 102,000 miles
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
F slow computer responses Ford Fusion Second Generation 0
C Lowbeam headlight inop troubleshooting General Automotive Discussions 1
U Fog light bulbs replaced General Automotive Discussions 0
K Replaced all 3 engine mounts...now car won't crank. Ford Fusion First Generation 3
2 2010 Milan Low Voltage at Right Rear Turn Signal Ford Fusion First Generation 0
P Yellow Wrench light and loss in MPG Ford Fusion Hybrid 0
K 09 Fusion, Subframe/cradle won't lower Ford Fusion First Generation 0
J Making ticking noise and idles low Ford Fusion Maintenance, Warranty Issues & Trouble 1
W Mass Airflow Sensor Harness Connector 08 Milan 2.3l 4cyl Ford Fusion First Generation 0
dyn085 The Official Lowered/Slammed/Stanced Picture Thread Ford Fusion Wheels, Tires, Suspension & Brakes 0

Similar threads

Share This Page

New Ford Fusion Posts



Top